Доброго дня всем. 

Помогите распиновкой на Bosch ME 9.2.2  Bmw x5 e70 4.8  Нужно с разбором сделать эбу. 

 

Стандартная BDM площадка. 

Так там же обчная, BDM площадка, как у EDC16

BOSCH ME9+2 BMW

 

WARNING: to use this protocol of communication you have to remove and open the ECU. It is a risky operation, to be done with great care and caution to avoid damaging the ECU beyond repair.
After opening the ECU and before proceeding with reading and/or programming, you are strongly advised to reconnect the unit to the vehicle and start the engine, to make sure it still works.
In no event shall we be liable for any damage caused to the ECU during the opening.
BY USING THIS PROTOCOL, YOU CONFIRM YOUR FULL AND UNCONDITIONAL ACCEPTANCE OF THIS TERMS AND CONDITIONS, YOU RELIEVE US FROM ANY RESPONSABILITY AND YOU RENOUNCE TO ALL RIGHTS TO CLAIM ANY COMPENSATION.

 

On this type of ECU you can make reading and programming in two different ways:
- direct connection to the ECU using the flat cable 144300T100 some strips to be soldered
- using the positioning frame 14P800ADBO, the flat cable 144300T100 and the special board 14AM00T01M

Flat Cable 144300T100

 

Positioning frame 14P800ADBO, flat cable 144300T100 and special board 14AM00T01M

 

Before programming, we suggest you make a backup copy of the ECU.

 

1. Remove the ECU from the vehicle;
2. Open the ECU, taking care not to damage the parts on the inside;
3. Reconnect the ECU to the vehicle and start the engine, in order to make sure that it is still working and has not been damaged during the opening;
4. Remove again the ECU from the vehicle;
5. Select the right family;
6. Make the backup of the data on the ECU.

Backup window of a Master Tool

 

Backup window of a Slave Tool

 

 

 

The programming pins are in the lower part of the ECU.

 

Direct connection to the ECU

1. Solder the strips to the programming pins, starting from the left:
    
2. Connect the flat cable to the strips soldered on the ECU. Keep the colored stripe of the flat cable to the left, as shown in the picture:
    
3. Proceed with the reading or programming.

 

Connection with positioning frame

1. Put the ECU in the positioning frame;
2. Place the special board 14AM00T01M into the compartment;
3. Connect the flat cable 144300T100 to the special board;
4. Connect the other end of the flat cable to the tool;
5. Lower the special board on programming pins as shown in the picture:
   
   
    
6. Proceed with the reading or programming.

Читай хелп китага.

Изменено 5 марта 20179 г пользователем Владимирыч

Да, БДМ есть))) Не сталкивался с таким раньше. 

 

Питание на разьемах вызвонил,  не могу найти "IGN 12v"

 

Всем спасибо) Подал питание через бдм 

Изменено 5 марта 20179 г пользователем Scorpion1

Я по обд делал , правда долго читается.

Я не стал рисковать через розетку )